On the Dial-Out Connections tab of the ISDN Data Connections dialog, you define the parameters which the camera uses to dial-out to the Internet or an ISDN router via ISDN (e.g. to transfer an image or send an e-mail).To edit the ISDN connections for dialing in, click on the Dial-In Connections tab; certain parameters for dialing out (Dialing Pause, Dial-Out Limits) can be configured on the Dial-Out Parameters tab.
You can configure up to six different dial-out connections. Four of these can be active at the same time. Active connections are highlighted.
|inactive||Deactivates the connection. The settings remain stored in the configuration.|
|remove||Deletes this entry from the configuration.|
|Set as default route||Sets the default route to this connection. For configuring additional routes, go to the Routing dialog. For additional information see the Routing help page.|
|Note:||If you have activated the BOOTP/DHCP option in the Ethernet Interface dialog, the Default Route is always set to the Ethernet Interface.|
Click on the Set button to activate your settings and to save them until the next reboot of the camera.
Click on the Close button to close the dialog. While closing the dialog, the system checks the entire configuration for changes. If changes are detected, you will be asked if you would like to store the entire configuration permanently.
In order to enable these settings, you need to store the configuration and reboot the camera!